This is an old revision of the document!

Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103

Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103

4521 Build Instructions

The 4521 PCB assembly contains components that are sensitive to electrostatic discharge (ESD) – please make sure you are wearing your wrist strap when handling.

Select Case Cover 201030 for 4 Channel Temperature Module

Assemble 4 off (203943) M3 x 5 mm standoffs as shown to studs on underside of case cover.

Remove the nut and o-ring from the can connector plug. (this will enable it to assemble into the cover)

You can now flash the software to the PCB and test for function

Connect the PCB to the AVR programming module and connect the CAN connector plug to a 12vSource, and follow the screens as detailed below.

Assemble the programmed circuit board as shown to the case, screw 4 off 201485 nuts onto studs to retain circuit board using a torque of 1.0 Nm as shown below