Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:3155 [2023/11/27 08:54] – kacper
+++ internal:proddocs:3155 [2023/11/27 10:16] (current) – kacper
@@ Line 5: / Line 5: @@
 Connect the Modbus to the NMEA Network and STM32 Programmer
-INSER IMAGE
+{{:internal:proddocs:3155setup.jpg?600|}}
 Turn on 12V NMEA Power.
-INSERT IMAGE
+{{:internal:proddocs:3155supply.jpg?600|}}
 Open STM32CubeProgrammer and open the programming tab
@@ Line 61: / Line 61: @@
 Connect the USB to RS-485 Converter to the 3155 screw in terminal blocks as shown, tighten with flat head screwdriver (**not too hard**).
-{{:internal:proddocs:modbus_3155.jpg?800|}}
+{{:internal:proddocs:3155modbusconnection.jpg?600|}}
 ==== Step 2 ====
@@ Line 126: / Line 126: @@
 {{:internal:proddocs:rtu_value_receive.png?800|}}
-**If a Values are received successfully then testing is completed**
+Now test the modbus configuration by setting the Hex switch on the 3155 to '6'. Press a magnet up to the reed swith, the Blue led should light solid blue.
-==== Packaging ====
+Set Qmodbus master settings again to 4,800 Baudrate, Odd Parity, 1 stop bit
-{{:internal:proddocs:3155..1.jpg?600|}}
+{{:internal:proddocs:3155-6-settings.png?600|}}
+the hex switch should have been left on '6', so now change the slave address to 22
+{{:internal:proddocs:3155-slaveaddress22.png?600|}}
+Request the data again and the data shown should be the same as above
+**If a Values are received successfully then testing is completed - RETURN SWITCH TO 0 AND PRESS MAGNET TO DEVICE TO RETURN TO DEFAULT SETTINGS**
+==== Packaging ====
 Use RPT112  with Insert 200374