User Tools

Site Tools


internal:proddocs:3185

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
internal:proddocs:3185 [2022/09/12 08:50] chrissyinternal:proddocs:3185 [2023/07/12 14:33] (current) – external edit 127.0.0.1
Line 70: Line 70:
  
 **At this point programming and verification on this device (J1939 to NMEA2000 adaptor) is now complete you may now disconnect the CAN power connector and the MPLAB ICD 3 RJ-11 connector. **At this point programming and verification on this device (J1939 to NMEA2000 adaptor) is now complete you may now disconnect the CAN power connector and the MPLAB ICD 3 RJ-11 connector.
 +
  
 {{:internal:proddocs:3185.1.png?600|}} {{:internal:proddocs:3185.1.png?600|}}
  
  
-====== Testing ====== 
  
 +====== Testing Procedure======
  
  
-**Select the test equipment from the shelf**+Select the test equipment from the shelf
  
  
Line 87: Line 88:
  
  
 +Get this test equipment from the shelf
 +Using test lead, fit 3x wires
 +White / black / blue
 +
 +Connect the J1939 simulator
 +Note –you will require 3 cables from the network to do the test,
 +
 +Once this is connected, the green LED will also flash rapidly.
 +
 +{{:internal:proddocs:3185..11.png?600|}}
 +
 +Image with all 3 cables connected below.
 +
 +{{:internal:proddocs:3185..12.png?600|}}
 +
 +See pic below for program.
 +
 +{{:internal:proddocs:3185..13.png?600|}}
 +
 +Check all instances again
 +
 +Check the up / down buttons, as long as the values change the unit is ok.
 +
 +This completed programming and test.
 +
 +Add 4x 200943 spacers to existing studs in metalwork.
 +
 +Place the board 10262 in to the housing. Remove the rubber grommet and nut from PL1.
 +
 +
 +{{:internal:proddocs:3185..14.png?600|}}
 +
 +Screw 201485 onto studs using the 5mm long socket securing the board to the housing.
 +Taking time to align the two switches with the top cover.
 +
 +
 +{{:internal:proddocs:3185..15.png?600|}}
 +
 +
 +Place the rear cover 201030 on to the unit and screw down using screw 201074 making sure the countersunk holes are facing outwards towards you.
 +
 +{{:internal:proddocs:3185..16.png?600|}}
 +
 +Once the backing plate is secured, place the Oceanic Systems product description and serial number sticker onto the unit side panel square and central as shown.
 +
 +{{:internal:proddocs:3185-16.png?600|}}
 +
 +This can now be packed into its box with sleeve and QC label.
 +
 +
 +
 +
  
  
internal/proddocs/3185.1662972641.txt.gz · Last modified: 2023/07/12 14:11 (external edit)

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki