Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:3281 [2022/05/03 09:26] – chrissy
+++ internal:proddocs:3281 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 59: / Line 59: @@
 **The sender is now ready for programming.**
-need new info here
+<note>**Connect the Sender head to the NMEA cable and power on the device
+Connect the ST/LINK v2 to the programming header. You will need the PCB to be loose from the sender head to be able to access it, as it is on the under-side of the board.
+Open STM32CubeProgrammer
+Click the Icon on the left hand side:**** 5) Click the connect button.**</note>
+**Browse to the folder S:\Code\Production\3281 water Level Sender\Program AFTER Rev J\
+Then select 3281bootloader.bin**
+{{:internal:proddocs:3281...jpg?600|}}{{:internal:proddocs:img_20220505_150521.jpg?600|}}
+**Ensure the check boxes are as shown below and then select “Start Programming”**
+{{:internal:proddocs:img_20220506_074850.jpg?600|}}
+<note important>**Now, the blue LED should be on solid.
+Open Monex 3.12, Select the Programming tab, and then press “3281”**
+</note>
+{{:internal:proddocs:img_20220505_150709.jpg?600|}}
+**Press the re-program button**
+{{:internal:proddocs:3271..6.png?600|}}
+**Navigate to S:\Code\Production\3271 Fuel Level Sender\Program AFTER Rev J and select 3271-v5.bin, then press “open”.
+**
+**Browse to the folder S:\Code\Production\3281 water Level Sender\Program AFTER Rev J\
+Then select 3281bootloader.bin**
+**The tool will now indicate it is programming, it will then show a CRC and PASS, and finally will reboot to application code.**
+{{:internal:proddocs:3271..8.png?600|}}
 <note important>**Before potting, allow the senders to acclimatise in the potting room for a couple of hours. This will reduce the chance of any condensation on the inner sender body.**</note>