Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:3410 [2022/04/08 07:38] – chrissy
+++ internal:proddocs:3410 [2026/05/18 08:00] (current) – updated current values via notes to account for equipment aging zbigniew
@@ Line 65: / Line 65: @@
 **Power up**
-**Set Power Supply to 8.6v**
+**Try Setting Power Supply to 8.6v. The voltage will fluctuate slightly**
 **Check Voltage of NMEA power supply and record. (Right hand terminals of the power
@@ Line 89: / Line 89: @@
 Check the voltage is the same as recorded in the previous procedure, see pic below.**
+<note important>** For this, the current should MATCH what's on the power supply. If the screen shows 50, PSU should also say 50 +/-3 **</note>
 {{:internal:proddocs:3410.16.png?600|}}
@@ Line 99: / Line 101: @@
 White (5)
 Green (4)
-Red (6)**</note>
+Red (6) see pic below**</note>
+{{:internal:proddocs:3410.17.png?600|}}
+**Toggle power of PSU in front of you.
+(Turn off and on again). see pic below**
+{{:internal:proddocs:3410.18.png?600|}}
+{{:internal:proddocs:3410.19.png?600|}}
+<note important>** For this, the Current on screen should be about 3.2 times the current on the PSU, +/-5 . For example
+on screen - 50 on PSU, 130 on screen - 40 on PSU etc.  **</note>
+**End of test**
+<adm warning>Add x6 pcs 203017 slim washers to connector PL1 before placing it inside black plastic housing.</adm>
+{{:internal:proddocs:img_20230626_143339.jpg?600|}} {{:internal:proddocs:img_20230626_143350.jpg?600|}}
+**Fit PCB to case – remove plastic grommet from PL1**
+**Fit 203017 shim washer between PL1 nut and case.**
+**Fit base plate – ensure all holes line up for fixings**
+**The base plate is to be glued in place
+**
+add pics here
+**Packaging**
+add pics