Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:3410 [2022/04/08 07:47] – chrissy
+++ internal:proddocs:3410 [2026/05/18 08:00] (current) – updated current values via notes to account for equipment aging zbigniew
@@ Line 65: / Line 65: @@
 **Power up**
-**Set Power Supply to 8.6v**
+**Try Setting Power Supply to 8.6v. The voltage will fluctuate slightly**
 **Check Voltage of NMEA power supply and record. (Right hand terminals of the power
@@ Line 89: / Line 89: @@
 Check the voltage is the same as recorded in the previous procedure, see pic below.**
+<note important>** For this, the current should MATCH what's on the power supply. If the screen shows 50, PSU should also say 50 +/-3 **</note>
 {{:internal:proddocs:3410.16.png?600|}}
@@ Line 111: / Line 113: @@
 {{:internal:proddocs:3410.19.png?600|}}
+<note important>** For this, the Current on screen should be about 3.2 times the current on the PSU, +/-5 . For example
+on screen - 50 on PSU, 130 on screen - 40 on PSU etc.  **</note>
 **End of test**
+<adm warning>Add x6 pcs 203017 slim washers to connector PL1 before placing it inside black plastic housing.</adm>
+{{:internal:proddocs:img_20230626_143339.jpg?600|}} {{:internal:proddocs:img_20230626_143350.jpg?600|}}
 **Fit PCB to case – remove plastic grommet from PL1**