Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:3478 [2023/06/21 09:19] – kacper
+++ internal:proddocs:3478 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 28: / Line 28: @@
 Connect unit to programming device.
-{{:internal:proddocs:sam2_conn_prog.jpg?600|}}
+{{:internal:proddocs:3478conn.jpg?600|}}
   * Select STM32CubeProgrammer
@@ Line 39: / Line 39: @@
 {{:internal:proddocs:inkedprogramming_tab.jpg?600|}}
-  * Browse and select the S:/Code/Production/3271-SAM2/3271-SAM2-Bootloader
+  * Browse and select the S:/Code/Production/3478/3478Bootloader
-{{:internal:proddocs:sam2bootloaderdirectory.png?600|}}
+{{:internal:proddocs:3478bootloaderlocation.png?600|}}
     * Click Start Programming Making sure all the checked boxes are correct
-{{:internal:proddocs:sam2progbootloaderfinished.png?600|}}
+{{:internal:proddocs:3478progbootloadersuccess.png?600|}}
 You can now disconnect the unit, if programming unsucessful, erase the device memory and try again.
@@ Line 51: / Line 51: @@
   * Open Monex and click 'Get Serial' and 'GetProdInfo', you should see the following
-{{:internal:proddocs:sam2monexprodinfo.png?600|}}
+{{:internal:proddocs:3478bootloaderprodid.png?600|}}
   * Go to the Programming tab and match the device instance to the Target Select
@@ Line 57: / Line 57: @@
 {{:internal:proddocs:targetprog.png?600|}}
-  * Click on 3271-SAM2 and the Reprogram on the pop-up
+  * Click on 3478 and the Reprogram on the pop-up
-  * Select S:/Code/Production/3271-SAM2/3271-SAM2
+  * Select S:/Code/Production/3478/3478
-{{:internal:proddocs:sam2programsoftware.png?600|}}
+{{:internal:proddocs:3478progsoftware.png?600|}}
   * The Device should start programming and should 'PASS', and Reboot to Application Code
-  * Go Back to Device Info Tab and check that Model ID now shows as Sender Averaging Module
+  * Go Back to Device Info Tab and check that Model ID now shows as Relay Output Module 8
-{{:internal:proddocs:sam2prodinfoafterprog.png?600|}}
+{{:internal:proddocs:3478softwareprodid.png?600|}}
 ===== Test procedure =====
@@ Line 73: / Line 73: @@
 Device Info and Instance switch testing should still be completed.</note>
-  - Close Flip, Atmel Studio and Monex.
+  - Close all programs, keep Monex open
   - Open relay program at S:/Code/Published PC Programs/Relay Board Tester/x64/RelayBoardTester.exe
   - Turn on all of the switches individually, check the green LEDs come in and you hear a switching noise.