This is an old revision of the document!
Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103
Table of Contents
3501 Build instructions
Programming
Connect the unit to 24V NMEA power as shown
Connect the STM32 Programmer to the unit as shown
Open STM32 Programmer and go into the programming tab
Select the 'File Path' to be S:/Code/Production/3501/3501Bootloader
Click “Connect” in the top right corner and make sure all the boxes are checked as shown below and click “Start Programming”
You can now remove the STM32 programmer from the PCB, the Blue LED should be solid blue.
Now Open Monex Software (found in S:/Code/Published PC Programs/Monex3
On the Device Info Tab click, 'Get Serial' and 'Get PodInfo', you should see the following:
Go To the 'Programming' Tab and click on 3501, and then on 'Reprogram!' on the pop-up that appears
Then select vessel for which the unit will be used from S:/Code/Production/3501/….
For Testing Purposes PEARL62 is used:
The Programming will begin, wait until “Re-booting to Application Code” is displayed before you begin testing
