Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:4410 [2023/06/21 12:35] – kacper
+++ internal:proddocs:4410 [2023/12/04 10:21] (current) – kacper
@@ Line 50: / Line 50: @@
   * Go Back to Device Info Tab and check that Model ID now shows as Switch Input Module
+{{:internal:proddocs:4410progprodinfo.png?600|}}
+====== Test Procedure ======
+<note tip>You are now ready to test the unit using Switch Input Test software (may display as “4410” if on your desktop (s/code/published PC programs/CLI/SwitchInputTester if not already installed on your machine)
+</note>
+Connect the CAN to the CAN chassis plug on the logic board as shown in picture and power with 30V, place a +30 volt power supply into pins 1 and 2 of the terminal block connector - the LED should light green indicating power is on..
+{{:internal:proddocs:4410_30v.jpg?600|}}
+{{:internal:proddocs:4410_initial_connect.jpg?600|}}
+Test all inputs one by one using the probe and monitoring the output in the test program, the voltage applied to each input should also be +30V. Also make sure that each input LED, alongside the software test program output changing.
+{{:internal:proddocs:4410_pin_1.jpg?600|}}
+{{:internal:proddocs:4410_pin_2.jpg?600|}}
-====== Test Procedure ======
-<note tip>You are now ready to test the unit using Switch Input Test software (may display as “4410” if on your desktop (s/code/published PC programs/CLI/SwitchInputTester if not already installed on your machine)
-</note>
-Connect the CAN to the CAN chassis plug on the logic board as shown in picture, place a +12 or +24 volt power supply into pins 1 and 2 of the terminal block connector.
-Test all inputs one by one using the probe and monitoring the output in the test program.
 {{:internal:proddocs:img_20230111_132706.jpg?600|}}
@@ Line 110: / Line 84: @@
 Screw 4 x 201076 onto the 4 x 201074.
-Place the board 10258-B in to the housing 201030 Remove rubber grommet and nut from PL1 and replace with shim washer x 5 203017.
+Place the board 10258-B in to the housing 201030 Remove rubber grommet and nut from PL1 and replace with shim washer x 8 203017.
 {{:internal:proddocs:4410-12.png?600|}}