Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:4410 [2023/07/24 09:53] – eral
+++ internal:proddocs:4410 [2023/12/04 10:21] (current) – kacper
@@ Line 57: / Line 57: @@
 </note>
-Connect the CAN to the CAN chassis plug on the logic board as shown in picture, place a +12 or +24 volt power supply into pins 1 and 2 of the terminal block connector.
+Connect the CAN to the CAN chassis plug on the logic board as shown in picture and power with 30V, place a +30 volt power supply into pins 1 and 2 of the terminal block connector - the LED should light green indicating power is on..
-Test all inputs one by one using the probe and monitoring the output in the test program.
+{{:internal:proddocs:4410_30v.jpg?600|}}
+{{:internal:proddocs:4410_initial_connect.jpg?600|}}
+Test all inputs one by one using the probe and monitoring the output in the test program, the voltage applied to each input should also be +30V. Also make sure that each input LED, alongside the software test program output changing.
+{{:internal:proddocs:4410_pin_1.jpg?600|}}
+{{:internal:proddocs:4410_pin_2.jpg?600|}}
 {{:internal:proddocs:img_20230111_132706.jpg?600|}}