Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:4521 [2022/03/07 15:57] – created chrissy
+++ internal:proddocs:4521 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
 ====== 4521 Build Instructions ======
+<note warning>The 4521 PCB assembly contains components that are sensitive to electrostatic discharge (ESD) – please make sure you are wearing your wrist strap when handling. </note>
 **Select Case Cover 201030 for 4 Channel Temperature Module**
@@ Line 16: / Line 16: @@
 <note important>**You can now flash the software to the PCB and test for function**</note>
+{{:internal:proddocs:4521.3.png?600|}}
+**Connect the PCB to the AVR programming module and connect the CAN connector plug to a
+vSource, and follow the screens as detailed below.**
+{{:internal:proddocs:4521.4.png?600|}}
+{{:internal:proddocs:4521.5.png?600|}}
+{{:internal:proddocs:4521.7.png?600|}}
+{{:internal:proddocs:4521.8.png?600|}}
+**Assemble the programmed circuit board as shown to the case, screw 4 off 201485 nuts onto studs
+to  retain circuit board using a torque of 1.0 Nm as shown below**
+{{:internal:proddocs:4521.9.png?600|}}
+**After assembling the four nuts the Base Cover 201030 is ready to be assembled**
+{{:internal:proddocs:4521.14.png?600|}}
+**The Base Cover 201030 is assembled using 4 off 201074 Torx mono drive screws tightened to a torque of 1.0Nm see below**
+{{:internal:proddocs:4521.15.png?600|}}
+**When fitting the nut for the M12 connector use shim washer 203017**
+{{:internal:proddocs:4521.16.png?600|}}
+**Affix self adhesive 200337 label to one end of cover, positioned centrally as shown.
+Label printed with Part Number
+Software revision, Serial Number,
+Channel Temperature Module, see below**
+{{:internal:proddocs:4521.10.jpg?600|}}
+**The serial number on the product
+    label, can now be assigned to the
+    product.
+   Connect the unit via the CAN lead from
+   the PC. In the Monex program
+   select SET SERIAL No you can now type
+   in the serial number.
+   You can now check that the unit has
+   Retained the information by selecting
+   GET PRODUCT INFO this should now
+   Display the PRODUCT NUMBER, SERIAL
+   NUMBER, HARDWARE and SOFTWARE
+   Version numbers.
+Basic temperature reading test can be carried out on Monex – note, red lights should be lit when test leads are not connected.
+**
+====== Packaging ======
+**
+Check manual for package contents**
+{{:internal:proddocs:4521.11.jpg?600|}}{{:internal:proddocs:4521.12.jpg?600|}}
+{{:internal:proddocs:4521.13.jpg?600|}}
+ --- //[[chrissy@osukl.com|Christine Walsh]] 08/03/2022 09:26//created