Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:5121 [2021/10/04 09:10] – chrissy
+++ internal:proddocs:5121 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 30: / Line 30: @@
 {{:internal:proddocs:5121-24.png|}} {{:internal:proddocs:5121-27.jpg?600|}}
+Fit heat spreader (203230) to Bezel using screws provided (use smallest screws here)
+{{:internal:proddocs:5121-26.png?600|}}
+Fit Sata board (203204) to (203208) board Use Loctite 222 with screw provided.
+{{:internal:proddocs:5121-30.png?600|}}
+Fit memory card (203303) to underside connection point of (203208) Board
+Add Heatsink compound to heat spreader
+Fix PCB (203208) into position with long screws provided with PCB, use Loctite 222
+Solder Red and Black wire from connector (202433) to power board
+(10293-A)
+{{:internal:proddocs:5121-31.png?600|}}
+Twist and solder the red and black wire and heat shrink into place
+{{:internal:proddocs:5121-34.png?600|}}
+Screw 10863 cable Red and Black into green connector on (203208)
+Plug the other end into PL4 (10293-A)
+{{:internal:proddocs:5121-3.png?600|}}
+{{:internal:proddocs:5121-31.jpg?600|}}
+Fit TFT using (202880) screws and loctite 222
+{{:internal:proddocs:5121-32.png?600|}}
+ Using the Glue gun, Glue the boards into place, see arrows
+{{:internal:proddocs:5121-32.jpg?600|}}{{:internal:proddocs:5121-35.png?600|}}
@@ Line 140: / Line 176: @@
 When this occurs, turn the monitor off and on again, and you should see the poseidon loading (Make sure the poseidon unit is turned on)
-If in doubt or the printer isnt printing ask DEV (But wait at least 20 minutes after screen goes dark to do so).
+If in doubt or the printer isnt printing ask DEV (But wait at least 20 minutes after screen goes dark to.
+**Silicone screen and leave to cure overnight. Once cured check for any holes.**
+{{:internal:proddocs:5015......png?600|}}{{:internal:proddocs:5015_screen.jpg?600|}}
+{{:internal:proddocs:5021.10.jpg?600|}}
+==== Manuals ====
+  * Labels (engineering need to assign a serial number)
+  * Go to (S) Drive.
+  * Parts Documents.
+  * Select 5121
+  * Select PDF's.
+  * Select 5121_user manual and print.
+<note important>Engineering need to issue Serial number before printing.</note>
+{{:internal:proddocs:5121-36.png?600|}}
+==== Packaging ====
+  * Use box 203408 with inserts
+  * Blue film
+  * Antistatic bubble wrap
+  * Packing chips
+{{:internal:proddocs:5121-33_2_.jpg?600|}}{{:internal:proddocs:5121-37_2_.jpg?600|}}
+{{:internal:proddocs:5121-36.jpg?600|}}
+ --- //[[chrissy@osukl.com|Christine Walsh]] 05/10/2021 07:59//
-**Programming Finished**