This is an old revision of the document!

Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103

Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103

Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103

Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103

Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103

Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103

5170 Build Instructions

The 5170 assembly contains components that are sensitive to electrostatic discharge (ESD) – please make sure you are wearing your wrist strap when handling.

Remove the cover of the NVR case (203706) = 3 screws Rotate the fan through 90 degrees making sure the power cable is on the bottom – nearest where the Motherboard will go.

Remove the Hard drive bracket near the fan.

Remove extra motherboard mounting post from the casing.

This is a bit tricky and will need a pair of grips to rotate the pin out of the case. Make sure there is no lose metal left behind.

Inside the Motherboard box, there will be the external components mask that will fit the hole at the rear of the case. Make sure this goes in place before you fix the Motherboard! This snaps into place from the inside – out.

Now prepare the PSU. This goes in the space at the front of the case.

Before you place the PSU completely, plug in the Hard-drive power cable into the PSU.

As you feed in the PSU into the case, feed the cables through the small hole in the case next to it.

Next remove the front hard-drive case and mount the hard-drive into it using the correct screws

. Do not over-tighten as the hard-drive will be cushioned by the rubber seals

Fit the Hard-drive and it’s housing back in place.

Now you can add the Motherboard,

make sure you have the right orientation and the screw holes line up with the pillars. Make sure you have already removed the spare pillar mentioned above! Screw the Motherboard into place gently. Do not over-tighten.