Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:5720 [2023/12/05 13:36] – kacper
+++ internal:proddocs:5720 [2023/12/07 11:50] (current) – kacper
@@ Line 26: / Line 26: @@
 Connect the NMEA 2000 power calbe and turn the power supply to 12V before turning it on.
-INSERT IMAGE
+{{:internal:proddocs:5720_nmea_power.jpg?600|}}
 Connect the STM32 Programmer to CONN2 on the 5720 PCB as shown below
-INSERT IMAGE
+{{:internal:proddocs:5720_stm32_programmer_conn2.jpg?600|}}
 Open STM32 Programmer, click 'Connect' and go to the Programming tab
@@ Line 47: / Line 47: @@
 You can now close the STM32 programmer and open Monex
-Click on Get Serial and Get ProdInfo, you should see the same as below:
-INSERT IMAGE
 Go to the Fuel Flow Tab and click 'Reprogram!', then choose S:/Code/Production/5720/5720 Fuel Flow
@@ Line 61: / Line 57: @@
 Connect the unit to the 5720 Testing Rig
-INSERT IMAGE
+{{:internal:proddocs:5720_test_rig.jpg?600|}}
 Open Monex on the 'Fuel Flow' Tab and set the Instances and values to match the image below:
@@ Line 77: / Line 73: @@
 {{:internal:proddocs:5720_initial_setup_values_2.png?600|}}
-Now set the left switch (L) Up, The flow should be approximately 3000, Flow total should be incrementing approximately every second. Return Flow should remain 'Unavailable'.
+The Tests Below will Require you to change the state of the switches on the test rig:
+{{:internal:proddocs:5720_switches.jpg?600|}}
+**Now set the left switch (L) Up**
+The flow should be approximately 3000
+Flow total should be incrementing approximately every second
+Return Flow should remain 'Unavailable'.
+**Now set the left switch (L) Down**
+The Return flow should be approximately 3000
+Return Total should be incrementing approximately every second
+Flow Should remain 'Unavailable'.
+**Return the Left switch (L) to the middle position**
+**Now set the Right switch (R) Up**
+The flow and Return should remain 'Unavailable'
+The Flow Total should decrement approximately every 6 seconds.
-Now set the left switch (L) Down, The Return flow should be approximately 3000, Return Total should be incrementing approximately every second. Flow Should remain 'Unavailable'.
+**Now set the Right Switch (R) Down**
-Return the Left switch (L) to the middle position
+The Return flow should be approximately 600
-Now set the Right switch (R) Up, The flow and Return should remain 'Unavailable' and the Flow Total should decrement approximately every 6 seconds.
+Return Total should increment approximately every 6 seconds.
-Now set the Right Switch (R) Down, The Return flow should be approximately 600, Return Total should increment approximately every 6 seconds.
+**Now return the Right Switch (R) to the middle position**
-Now return the Right Switch (R) to the middle position.
+**Now Click both 'Reset Flow Total' and 'Reset Return Total'**
-Now Click both 'Reset Flow Total' and 'Reset Return Total' - both totals should return to '0'
+Both totals should return to '0'