Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:5980 [2025/08/29 08:11] – created david
+++ internal:proddocs:5980 [2025/09/16 10:52] (current) – david
@@ Line 1: / Line 1: @@
-====== 5390 Build Instructions ======
+====== 5980 Build Instructions ======
+<note warning>The 5980 PCB assembly contains components that are sensitive to Electrostatic discharge (ESD)- Please make sure you are wearing your wrist strap when handling.</note>
+====== 1. Programme the board ======
+Find and connect the test board and Atmel programmer as shown.
+{{:internal:proddocs:5980aa.jpg?400|}}
+{{:internal:proddocs:5980ab.jpg?800|}}
+{{:internal:proddocs:5980ac.jpg?400|}}
+{{:internal:proddocs:5980ad.jpg?100|}}
+{{:internal:proddocs:5980ae.jpg?800|}}
+{{:internal:proddocs:5980af.jpg?800|}}
+{{:internal:proddocs:5980ag.jpg?800|}}
+{{:internal:proddocs:5980ah.jpg?800|}}
+{{:internal:proddocs:5980ai.jpg?600|}}
+{{:internal:proddocs:5980aj.jpg?600|}}
+{{:internal:proddocs:5980ak.jpg?600|}}
+{{:internal:proddocs:5980al.jpg?600|}}
+{{:internal:proddocs:5980am.jpg?600|}}
+{{:internal:proddocs:5980an.jpg?600|}}
+====== 2. Build the unit ======
+Take the programmed board and remove the nut and washer from the NMEA connector if fitted.
+{{:internal:proddocs:5980a.jpg?400|}}
+Add 5 x light pipes(203179), making sure they fit flush at the bottom.
+{{:internal:proddocs:5980b.jpg?400|}}
+Add 4 x standoffs(203300) and secure with screws(202617) and washers(200508).
+{{:internal:proddocs:5980c.jpg?400|}}
+Fit the metal shield(203178-C), making sure the pipes fit in the holes.
+{{:internal:proddocs:5980d.jpg?400|}}
+Secure with 4 x screws(201075).
+{{:internal:proddocs:5980e.jpg?400|}}
+Fit the label(203209), making sue the holes all line up correctly.
+{{:internal:proddocs:5980f.jpg?400|}}
+Take the base(203184) and the foot(203182).
+{{:internal:proddocs:5980g.jpg?400|}}
+Fit together, keeping the foot central.
+{{:internal:proddocs:5980h.jpg?400|}}
+Screw on 1 x side plate(203181) and secure with 2 x screws(203183).
+{{:internal:proddocs:5980i.jpg?400|}}
+Slide the board into the base, ensuring correct orientation.
+{{:internal:proddocs:5980j.jpg?400|}}
+Fit the other side plate and secure as before.
+{{:internal:proddocs:5980k.jpg?400|}}
+Refit the washer to the NMEA connector and add the 10way connector block().
+{{:internal:proddocs:5980l.jpg?400|}}
+Fit the serial No. label as below.
+{{:internal:proddocs:5980m.jpg?400|}}
+====== 3. Pack the unit ======
-**Programming Procedure**