Oceanic Docs

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== 5980 Build Instructions ======

<note warning>The 5980 PCB assembly contains components that are sensitive to Electrostatic discharge (ESD)- Please make sure you are wearing your wrist strap when handling.</note>

====== 1. Programme the board ======

Find and connect the test board and Atmel programmer as shown.

{{:internal:proddocs:5980aa.jpg?400|}}

{{:internal:proddocs:5980ab.jpg?800|}}

{{:internal:proddocs:5980ac.jpg?400|}}

{{:internal:proddocs:5980ad.jpg?100|}}

{{:internal:proddocs:5980ae.jpg?800|}}

{{:internal:proddocs:5980af.jpg?800|}}

{{:internal:proddocs:5980ag.jpg?800|}}

{{:internal:proddocs:5980ah.jpg?800|}}

{{:internal:proddocs:5980ai.jpg?600|}}

{{:internal:proddocs:5980aj.jpg?600|}}

{{:internal:proddocs:5980ak.jpg?600|}}

{{:internal:proddocs:5980al.jpg?600|}}

{{:internal:proddocs:5980am.jpg?600|}}

{{:internal:proddocs:5980an.jpg?600|}}

====== 2. Build the unit ======

Take the programmed board and remove the nut and washer from the NMEA connector if fitted.

{{:internal:proddocs:5980a.jpg?400|}}

Add 5 x light pipes(203179), making sure they fit flush at the bottom.

{{:internal:proddocs:5980b.jpg?400|}}

Add 4 x standoffs(203300) and secure with screws(202617) and washers(200508).

{{:internal:proddocs:5980c.jpg?400|}}

Fit the metal shield(203178-C), making sure the pipes fit in the holes.

{{:internal:proddocs:5980d.jpg?400|}}

Secure with 4 x screws(201075).

{{:internal:proddocs:5980e.jpg?400|}}


Fit the label(203209), making sue the holes all line up correctly.

{{:internal:proddocs:5980f.jpg?400|}}

Take the base(203184) and the foot(203182).

{{:internal:proddocs:5980g.jpg?400|}}

Fit together, keeping the foot central.

{{:internal:proddocs:5980h.jpg?400|}}

Screw on 1 x side plate(203181) and secure with 2 x screws(203183).

{{:internal:proddocs:5980i.jpg?400|}}

Slide the board into the base, ensuring correct orientation.

{{:internal:proddocs:5980j.jpg?400|}}

Fit the other side plate and secure as before.

{{:internal:proddocs:5980k.jpg?400|}}

Refit the washer to the NMEA connector and add the 10way connector block().

{{:internal:proddocs:5980l.jpg?400|}}

Fit the serial No. label as below.

{{:internal:proddocs:5980m.jpg?400|}}


====== 3. Pack the unit ======