Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:9101 [2023/01/12 11:19] – kacper
+++ internal:proddocs:9101 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 15: / Line 15: @@
 ===== Assembling/Connecting and Testing Seatek Engine Adapter using Test Box =====
 **This Section outlines all connections that need to be made before testing can begin and all testing that follows**
+==== Before Starting ====
+Before you begin testing you must cut a track on the PCB with a scalpel and carry out a continuity check using a multimeter to make sure the track is definitely cut.
+The track you should cut is shown below:
+{{:internal:proddocs:cutting_track.jpg?800|}}
 ==== Step 1 ====
@@ Line 336: / Line 342: @@
 INSERT IMAGE OF MONEX
+If there is no rapid toggling then hold down the stop button on the test box and proceed to turn the ignition switch all the way to the right - On monex the STOP button should not be lit, while the START button should light Yellow.
+IF THIS IS NOT THE CASE THEN STOP TESTING AND ASK DEV
+Now hold down the STOP button again, and click START on monex - START should not light, and STOP should be constantly lit RED.
 **Return all switched to position 1 and return the ignition switch to the starting vertical position*