Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:3125 [2022/06/22 07:43] – [Packaging] chrissy
+++ internal:proddocs:3125 [2025/05/20 10:39] (current) – david
@@ Line 69: / Line 69: @@
 <note>1 x bag is sufficient to fill 6 units.</note>
- Warm the compound on the heat plate (to approx 35/40°c), this takes approximately 5 minutes. Do not warm above this temperature as it will greatly reduce the pot life of the compound.
+Warm the compound in the water bath (this should be set to 40 degrees), this takes approximately 10 minutes for the bath to come up to temperature and 5 minutes to warm a bag of compound. Do not warm above this temperature as it will greatly reduce the pot life of the compound. Once warm, work the black potting BEFORE removing the clip and rail – this will help remove any lumps caused by the fillers that have settled over time. Then, place back into the bath for 2 minutes. Remove the clip and rail, and mix thoroughly for approximately 2 minutes.
-Once warm, work the black potting BEFORE removing the clip and rail – this will help remove any lumps caused by the fillers that have settled over time. Then, put back on to the heat plate for 1 minute.
-Remove the clip and rail, and mix thoroughly for 2 minutes.
+REMEMBER TO TURN THE WATER BATH OFF ONCE YOU HAVE FINISHED WITH IT !
 .  Holding the bag vertically snip about 10 mm off the top corner at 45 degrees with a pair of scissors. Now drizzle the Epoxy over the circuit board to a level, taking care not to get any on the LED or Dial face. Allow to harden overnight. This will allow the mixture to settle.
@@ Line 89: / Line 89: @@
 Connect to Monex and assign serial number to the units using the set serial function.
-{{:internal:proddocs:20210914_104432_2_.jpg?600|}}
+{{:internal:proddocs:img_20220622_082434.jpg?600|}}
 ====== Packaging ======
-Use RPT108 and bubble bag
+Use RPT108 and bubble bag, make to to include the 3829 cable and instruction book.
 <note important>one pic is for picture is for the Honda</note>
 Standard will be the same label size only box label will be our standard product and sleeve.
-{{:internal:proddocs:20210914_113210_2_.jpg?600|}}
 {{:internal:proddocs:20210914_113558_2_.jpg?600|}}