Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:3210-dual [2022/09/13 11:35] – chrissy
+++ internal:proddocs:3210-dual [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 2: / Line 2: @@
 <note warning>The 3210-Dual PCB assembly contains components that are sensitive to electrostatic discharge (ESD) – please make sure you are wearing your wrist strap when handling.</note>
+**First stage – inside of bezel must be cleaned with acetone to ensure good adhesion with the potting compound. Add gasket to the bezel then push out the centre piece. Try to avoid the gasket overlapping the bezel too much. **
+{{:internal:proddocs:sam2.12.png?600|}}
+**Peel off the backing and carefully stick the glass to the gasket, ensuring the writing is level when viewed from the front. This is toughened glass NOT polycarbonate, as polycarb will bow during extreme heat.**
+{{:internal:proddocs:3210-d1.png?600|}}
+**Polish the bezel face, and then cover with blue film for protection.**
+{{:internal:proddocs:d2.png?600|}}
+**Clear potting. Ensure this has been degassed before use. Carefully clean the glass to ensure it is grease free, and that the clear windows do not have finger prints etc. on the reverse side.  Pour a thin layer on to the glass. Smear compound over the display before lowering into the bezel. Leave for 48 hours before black potting stage**
+{{:internal:proddocs:d3.png?600|}}
+**Black potting – once the clear layer has cured, add a layer of black potting. Make sure that the potting does not cover the two switches.**
+{{:internal:proddocs:d4.png?600|}}