Solder wires to PCB and insert cable tie into position see pic below

Select device programming on Atmel Flip and load hex file required.

The device will program ensure all operation flows are green.

Select Monex 3.10 Select Prod info and set serial number.

• Go to level transmit controls and change Instance to A B and C

add pic here

• Click transmit to standby and change fuel levels to check function

add pic LED 3, 4 and 5 should blink green Click water and fuel LED 3, 4 and 5 should blink red. Change instance to D, E and F add pic here LED 3, 4 and 5 should be solid red and 67 and 8 inactive. Click water and fuel again LED 6, 7 and 8 should blink green.

Apply glue to LED's on board

Insert PCB into casing ensure it sits under the four taps, Tighten cable tie in position and insert yellow button. insert side panels into place (cut to size on cable side)

click the rest of the casing partially into place then insert front panel. Then insert sping into orange slider switch and click everything into place,

Test switch control on monex and check all information. Label unit with required labels and print Data sheet (no manual for this unit)

Use a RPT112 box and a 200374 insert