internal:proddocs:4410
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| internal:proddocs:4410 [2023/12/01 15:25] – kacper | internal:proddocs:4410 [2023/12/04 10:21] (current) – kacper | ||
|---|---|---|---|
| Line 58: | Line 58: | ||
| Connect the CAN to the CAN chassis plug on the logic board as shown in picture and power with 30V, place a +30 volt power supply into pins 1 and 2 of the terminal block connector - the LED should light green indicating power is on.. | Connect the CAN to the CAN chassis plug on the logic board as shown in picture and power with 30V, place a +30 volt power supply into pins 1 and 2 of the terminal block connector - the LED should light green indicating power is on.. | ||
| + | |||
| + | {{: | ||
| + | |||
| + | {{: | ||
| + | |||
| Test all inputs one by one using the probe and monitoring the output in the test program, the voltage applied to each input should also be +30V. Also make sure that each input LED, alongside the software test program output changing. | Test all inputs one by one using the probe and monitoring the output in the test program, the voltage applied to each input should also be +30V. Also make sure that each input LED, alongside the software test program output changing. | ||
| + | |||
| + | {{: | ||
| + | |||
| + | {{: | ||
| {{: | {{: | ||
internal/proddocs/4410.1701444302.txt.gz · Last modified: 2023/12/01 15:25 by kacper