Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:5015 [2022/02/21 09:43] – chrissy
+++ internal:proddocs:5015 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 6: / Line 6: @@
 Then using a small file, modify the cut out holes to suit the PCB.
 Mark the corners of the cut out as seen in pictures below**
 {{:internal:proddocs:5015.1.png|}} {{:internal:proddocs:5015.3.png|}}{{:internal:proddocs:5015.5.png|}}{{:internal:proddocs:5015.6.png|}}
 **Select 10851-B touch PCB,  cut 4 x square pieces of foam tape and place in position on either end of the board See pictures below.**
 {{:internal:proddocs:5015.8.png|}}{{:internal:proddocs:5015.9.png|}}
 <note tip>**(You require 2 pieces per side one on top of the other, peel off adhesive backing)**</note>
@@ Line 80: / Line 83: @@
 <note important>**Insert connectors, ensure PCB lays flat, when inserting, then insert modified cable connector into PCB, see pics below.**</note>
-{{:internal:proddocs:5015.30.png|}}{{:internal:proddocs:5015.28.png|}}{{:internal:proddocs:5015.29.png|}}
+{{:internal:proddocs:5015.30.png|}}{{:internal:proddocs:5015.28.png|}}{{:internal:proddocs:5015.31.jpg?600|}}
 **Place connector into position from the (203847 cable assembly) see pics below.**
-{{:internal:proddocs:5015.31.png|}}
+{{:internal:proddocs:5015.xxxx.png?600|}}
 <note important>**Unplug 10863 video card cables before programming**</note>
@@ Line 93: / Line 98: @@
-{{:internal:proddocs:50105.36.png?600|}}{{:internal:proddocs:5015.35.png?600|}}
+{{:internal:proddocs:5015.xx.png?600|}}{{:internal:proddocs:5015.35.png?600|}}
   -  Select Atmel studio
@@ Line 172: / Line 177: @@
 **Leave to cure overnight, check for holes, clean off any residue.**
-**Select label required and record serial number data.**
+**Select label required and record serial number data, add warranty label.**
+{{:internal:proddocs:5015.222.jpg?600|}}
-**Print manuals and check details.**
+**Print manuals and check details, select all products to go with screen.**
-Need pic here
+{{:internal:proddocs:5015.666.jpg?600|}}
-<note important>**Place blue film over screen tightly and add warranty label, ensure there is no foreign debris.**</note>
+<note important>**Place blue film over screen tightly , ensure there is no foreign debris.**</note>
-need pic
+{{:internal:proddocs:5015.111.jpg?600|}}
 **Wrap screen in bubble wrap, (being careful not to over wrap the ends) this will obstruct the foam inserts.**
-need pic
+{{:internal:proddocs:5015.333.jpg?600|}}
 **Finally fit labels in place on the final packaging see pic below.**
-{{:internal:proddocs:5015..22.jpg?600|}}
+{{:internal:proddocs:5015.444.jpg?600|}}
  --- //[[chrissy@osukl.com|Christine Walsh]] 21/02/2022 09:33//created