Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:5180 [2022/04/11 14:12] – chrissy
+++ internal:proddocs:5180 [2023/09/26 12:12] (current) – ryan
@@ Line 23: / Line 23: @@
 {{:internal:proddocs:5180.3.png?600|}}
-{{:internal:proddocs:5180.4.png?600|}}
+{{:internal:proddocs:5180....png?600|}}
 {{:internal:proddocs:5180.5.png?600|}}
@@ Line 71: / Line 71: @@
 {{:internal:proddocs:5180.12.png?600|}}
-<note tip>**Ensure jumpers are in desired locations – note, at this point the PCB has NOT been fitted to the case see pics below.**
+<note tip>**Ensure jumpers are in desired locations – note, at this point the PCB has NOT been fitted to the case see pics below.**</note>
   - **Image 1: 1 jumper**
@@ Line 150: / Line 150: @@
 Note – nut has a flat edge.
 Ensure notch is at the top of M12.**</note>
+<note important>**CAN CONNECTOR CABLE SOLDERING DIFFERS IF YOU HAVE NEW VERSION OF CAN BOARD. PLEASE CHECK BELOW FOR CHANGES.
+**</note>
+{{ :internal:proddocs:4166_can_board_update.jpg?nolink |}}
+{{ :internal:proddocs:img_20230418_083138.jpg?nolink |}}
 **See below pic.**
@@ Line 299: / Line 306: @@
 Give the unit a gentle shake to ensure there is nothing loose inside.
 **
+{{:internal:proddocs:5180.38.png?600|}}
+**Fit the void sticker.
+Pack into the box the unit was originally supplied in see pic below.**
+<note important>Ensure the power connector 203134 is FITTED before packing</note>
+{{:internal:proddocs:5180.39.png?600|}}