internal:proddocs:allen_gears
This is an old revision of the document!
Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103
Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103
Table of Contents
Allen Gears Build
10698-B Build procedure
Ensure all parts have been QC’d before proceeding
Use bubble wrap or similar under the display housing to avoid scratching the paint.
Fit foam (yellow backing) to display housing. All ends must meet up to provide a dust seal for the glass. Allow a slight gap around the inner metal edge to allow for compression once the TFT holder is bolted on, see pic below.
Add edge strip to prevent cable rubbing, and add foam strips and poly tape, see pic below
TFT
Cut a strip of polyester tape 10mm longer than one of the sides of the LCD unit and apply it to the metal bezel along the front of the LCD 5mm from the inside edge.
Leave 5mm overhang each end of the tape,
Fold the tape over and stick it down along the edge of the LCD unit; fold again and stick down along the back, see pics below
Software Notes
Board 202466 - I/O Board
Board 202465 - PT100 Board
Start Stop Module
Main Board SSD
internal/proddocs/allen_gears.1655365882.txt.gz · Last modified: 2023/07/12 14:11 (external edit)