Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:3130 [2022/02/24 10:54] – chrissy
+++ internal:proddocs:3130 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 83: / Line 83: @@
 {{:internal:proddocs:5-3130.jpg?600|}}
-  * Turn the supply off and wait for the Blue LED to turn on and return to normal operation (this can take up to 30 seconds)
+  * Turn the supply off and wait for the Blue LED to turn off and return to normal operation (this can take up to 30 seconds)
   * Connect a power supply to the pins on the PCB **AS SHOWN BELOW, PAY ATTENTION TO THE POLARITY OF THE CONNECTION!**
@@ Line 161: / Line 161: @@
 === Potting procedure ===
+**Before potting ensure PCB is flat and level to the casing.**
+need pic here
+<note warning>The bags of Epoxy resin are kept in the potting room - suitable PPE should be worn when using the two-part Epoxy potting compound e.g. rubber gloves, overalls</note>.
+<note>1 x bag is sufficient to fill 6 units.</note>
+ Warm the compound on the heat plate (to approx 35/40°c), this takes approximately 5 minutes. Do not warm above this temperature as it will greatly reduce the pot life of the compound.
+Once warm, work the black potting BEFORE removing the clip and rail – this will help remove any lumps caused by the fillers that have settled over time. Then, put back on to the heat plate for 1 minute.
+Remove the clip and rail, and mix thoroughly for 2 minutes.
+.  Holding the bag vertically snip about 10 mm off the top corner at 45 degrees with a pair of scissors. Now drizzle the Epoxy over the circuit board to a level, taking care not to get any on the LED or Dial face. Allow to harden overnight. This will allow the mixture to settle.
+<note warning> If any bubbles appear, these can be dispersed by gently, for a few seconds using a hot air gun on the lowest setting over the surface.</note>
+The Potting must now be left for 24 hours to cure and harden.
+{{:internal:proddocs:3130.1.jpg?600|}}
+After the units have been removed from the jig, remove any over spill from the jig so it is clean for the next use.
+Once the epoxy potting has cured, the serial number label can be adhered to the potting top of the product as shown. Position carefully,  the label is printed with:
+Product name and part number
+Serial Number
+Hardware and Software level.
+Connect to Monex and assign serial number to the units using the set serial function.
+{{:internal:proddocs:3130..1.jpg?600|}}
+====== Packaging ======
+Use RPT108 and bubble bag
+{{:internal:proddocs:3130..2.jpg?600|}}{{:internal:proddocs:3130..3.jpg?600|}}
+ --- //[[chrissy@osukl.com|Christine Walsh]] 28/02/2022 08:52//updated potting and packaging.