</note>

1. Open Atmel Studio.
2. ATMEL PROGRAMMING
3. FUSES: All off except BOOTRST and SPIEN
4. BOOTSIZE = 4096_7800
5. CKSEL = 16KCK/14CK +64ms (Last option)
6. Then program the fuses.
7. Select Hex file from
8. S:/Code/Production/3350
9. 3350 Black = 3350_Bv200.hex
10. 3350 Fuel = 3350_Fv200.hex
11. 3350 Grey = 3350_Gv200.hex
12. 3350 Water = 3350_Wv200.hex
13. Then program the memory.
14. Disconnect the PCB

Assemble the Display Board 10235 to the Engine Board 10236.

The unit is now connected to the Monex system to check the LED Function @100% and 88% this ensures that all LED bars required to illuminate are lit, and check the Alarm Light function.

Assemble the threaded socket through the hole in the Body moulding – leaving the rubber O-ring under the moulding.

Place Shake proof Washer 200926 or 202927 over the thread and secure in position by replacing the nut on the thread.

Now the Top Plate 200741 can be added over the buttons and LED display as Shown below.

The Self Adhesive Membrane 200753 is now attached to the front face.

}}

First peel the backing from the back of the membrane. Care must be taken to align the Membrane centrally and with the transparent window squarely in line with the LED display.

The Bezel moulding can now be assembled, but first the material feed sprue must be cut from the moulding using side cutters as shown (if this has been left on).

. Using the manual press the body moulding is gradually eased into the Moulded Bezel, rotating it approx

   15 degrees for each application of pressure – Care being taken not to damage the three snap features
   on the Bezel.
   A piece of cloth should be placed under the Bezel face to protect it from damage during this stage.

1. Go to (S) Drive.
2. Parts Documents.
3. Select 3350
4. Select PDF's.
5. Select 3350_user manual and print.

• - Choose labels required
• - Select (LabelDirect)
• - Close (Pop Up)
• - Go to file-open
• - Select - Parts documents
• - Select - 3350
• - Select - Labels
• - Select - UL_3350-F_vA-1.0.0.0 (fuel)
• - Select UL_3350-BW_vA-1.0.1 (black water)
• - Select UL_3350-W_vA-1.0.0.0 (water)
• - Select UL_3350-GREY_vA-1.0.1 (Grey water)
• - Highlight Serial number and change in Text box.
• - Go to Incrementing number Properties and change serial number.
• - Go to file -Print Setup
• - Select bradyBBP11-34L(copy 1) and select Calibrate.
• - label will calibrate.