internal:proddocs:3501
This is an old revision of the document!
Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103
Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103
Warning: Undefined array key 1 in /data/docs.osukl.com/public_html/lib/plugins/note/syntax.php on line 103
3501 Build instructions
The 3501 PCB assembly contains components that are sensitive to electrostatic discharge (ESD) – please make sure you are wearing your wrist strap when handling.
Solder wires to PCB and insert cable tie into position see pic below
Programming
Select device programming on Atmel Flip and load hex file required.
Ensure Bit rate is set to 500 Then click (init). Power up device whilst holding SW1 then hit connect you may have to do this twice if error code appears. Ensure BLJB is unticked and then hit run
The device will program ensure all operation flows are green.
Switch off PSU without pressing SW1
Select Monex 3.10 Select Prod info and set serial number.
Apply glue to LED's on board
Insert PCB into casing ensure it sits under the four taps, Tighten cable tie in position and insert yellow button. insert side panels into place (cut to size on cable side)
internal/proddocs/3501.1632303027.txt.gz · Last modified: 2023/07/12 14:11 (external edit)