Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:4161 [2023/03/23 09:23] – eral
+++ internal:proddocs:4161 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 48: / Line 48: @@
 .	Connect the AVR Programmer to the ISP interface PL3 of the 202325 board.
 {{ :internal:proddocs:4166-2.png?nolink&600 |}}
@@ Line 66: / Line 67: @@
 {{ :internal:proddocs:1.png?nolink&600 |}}
 Programming the main program via ISP:
@@ Line 78: / Line 78: @@
 . Then press the “Program” button.
 {{ :internal:proddocs:4166-3.1.png?nolink&600 |}}
@@ Line 83: / Line 84: @@
 <note warning>Ensure PCB modifications on 10862 have been completed before continuing. See pictures below.  S:\Parts\10862 John Deere Mods</note>
 {{ :internal:proddocs:4410-mod1.png?nolink&600 |}}
 {{ :internal:proddocs:4410-mod2.png?nolink&600 |}}
@@ Line 89: / Line 91: @@
 === Programming Instructions TX6Q Module===
 {{:internal:proddocs:4166_1.png?600|}}
@@ Line 142: / Line 145: @@
   - Place the jumper at PL1 to be across the two pins.
   - Keep the miniUSB cable connected to the board's SK2 and the PC
-  - Insert USB stick which contains the correct release data e.g. oceanic_112 into ‘USB 3’
+  - Insert USB stick which contains the correct release data into ‘USB 3’
   - Switch on the module (Toggle Red/Silver Switch).
   - After the flash stops and the linux tries to boot, you will see “Starting kernel” in PuTTy... turn the board off (toggle Red/Silver Switch) and turn the power of by 24V power supply.
@@ Line 174: / Line 177: @@
 {{  :internal:proddocs:4161-3.png?600  }}{{  :internal:proddocs:4161-4.png?600  }}{{  :internal:proddocs:4161-5.png?600  }}
-===== Electronics QC Checks =====
+===== QC CHECK & Mechanical Assembly =====
 Get the modification work peer checked – ensure all wires are securely soldered in the correct locations and heatshrink has been added where required.
@@ Line 195: / Line 198: @@
 {{  :internal:proddocs:4161-6.png?600  }}
-===== Mechanical Assembly =====
 <note tip>Flat edges of 3x CAN PCB holes may need filing slightly due to powder coating. Check fitment FIRST.</note>