Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:4166 [2023/02/27 09:55] – eral
+++ internal:proddocs:4166 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 10: / Line 10: @@
 Select 4166.
-select offshore_159.
+Select offshore_160.
 S:\Binaries for Embedded\4166
@@ Line 34: / Line 34: @@
 <note important>For Princess software use the same process above but select 4166-P2  (offshore_ 152) S:\Binaries for Embedded\4166-P2</note>
-<note>Where no shake proof washer is fitted, Thread lock is to be used.</note>
 **Before commencing build, program 10823 Dual Engine PCB and TX6Q module.**
 === Programming Instructions 10823 Dual Engine PCB===
@@ Line 159: / Line 159: @@
   - Power off board
-Programming Completed
+Programming Completed.
 ===== Electronic Assembly =====
+<note>Where no shake proof washer is fitted, Thread lock is to be used.</note>
 <note warning>Fit resistor 201331 to the Dual Engine PCB to location VDD. Fit on the top two pads as this is the configuration for the 4166 variant
@@ Line 173: / Line 175: @@
-===== QC CHECK =====
+===== QC CHECK & Mechanical Assembly =====
 - Ensure the external surfaces of the case are clean and not scratched – reject if they are damaged in any way.
@@ Line 213: / Line 215: @@
 Fit Dual Engine PCB
-<adm warning>Before fit Dual Engine PCB to the back case cut the long leads as much as possible, shown as below picture.</adm>
+<adm warning>Before fit Dual Engine PCB to the back case cut the long leads as much as possible (in the red circle), shown as below picture.</adm>
 {{ :internal:proddocs:cutting_leads_1.jpg?nolink&600 |}}
 Align with pins on CAN PCB and DSUB connector.