Differences

This shows you the differences between two versions of the page.

--- internal:proddocs:5115 [2022/03/14 11:27] – chrissy
+++ internal:proddocs:5115 [2023/07/12 14:33] (current) – external edit 127.0.0.1
@@ Line 14: / Line 14: @@
 ensure the + and – are in the correct position.
 Place heat shrink on cable (200584) and solder red and black wire to power connector (202433) on
-power PCB (10293-A) then heat shrink cable. See
+power PCB (10292-C) then heat shrink cable. See
 pic.**</note>
 {{:internal:proddocs:5121.12.png?600|}}
-<note>**Lightly De-burr 10851- B PCB and Use thin double sided tape on each end to hold in place, see pic below. Ensure all three pads have been modified.
+<note>**Lightly De-burr 10851- B PCB and Use thin double sided tape on each end to hold in place, see pics below. Ensure all three pads have been modified.
 **</note>
-{{:internal:proddocs:5115.1.png?600|}}
+{{:internal:proddocs:5115.1.png?600|}}{{:internal:proddocs:5115.2.png?600|}}
+<note>**Modify 10866 cable assy by removing current connectors and replacing them with 203793 crimp, and 203794 connector on one side.
+Then 203421 connector and 203422 crimp on the other end. (Ref 10871 drawing)
+**</note>
+**Insert holes on Bezel with 4 x (203324) Standoffs. Fix Power PCB
+into position using 4 x (202429) Screws and 4 x (200508) washers.**
+{{:internal:proddocs:5121-24.png?600|}}{{:internal:proddocs:5115.3.jpg?600|}}
+**Fit heat spreader (203230) to Bezel using screws provided (use
+smallest screws here, see pic below)
+**
+{{:internal:proddocs:5121-26.png?600|}}
+**Fit Sata board (203204) to (203208) board Use Loctite 222 with
+screws provided see pics below.**
+{{:internal:proddocs:5115.4.jpg?600|}}{{:internal:proddocs:5115.5.jpg?600|}}
+**Fit memory card (203303) to underside connection point of
+(203208) Board Add Heatsink compound to heat spreader Fix PCB
+(203208) into position with long screws provided with PCB, use
+Loctite 222.
+Solder Red and Black wire from connector (202433) to power
+board (10292-C) see pic below**
+{{:internal:proddocs:5121-31.png?600|}}
+**Twist and solder the red and black wire and heat shrink into place, see pic below**
+{{:internal:proddocs:5115.6.png?600|}}